Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (3 Of 13)
- DTC P0092-00: Fuel Pressure Regulator 1 Control Circuit High
- DTC P00D1-00: HO2S Heater Control Circuit Range/Performance Bank 1 Sensor 1
- DTC P00D2-00: HO2S Heater Control Circuit Range/Performance Bank 1 Sensor 2
- DTC P00D3-00: HO2S Heater Control Circuit Range/Performance Bank 1 Sensor 1
- DTC P00D4-00: HO2S Heater Control Circuit Range/Performance Bank 2 Sensor 2
- DTC P0106-00: Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance
- DTC P0107-00: Manifold Absolute Pressure/Barometric Pressure Circuit Low Input
- DTC P0108-00: Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- DTC P0111-00: Intake Air Temperature Sensor 1 Circuit Range/Performance
- DTC P0112-00: Intake Air Temperature Sensor 1 Circuit Low Input
- DTC P0113-00: Intake Air Temperature Sensor 1 Circuit High Input
- DTC P0116-00: Engine Coolant Temperature Circuit Range/Performance
- DTC P0117-00: Engine Coolant Temperature Circuit Low Input
- DTC P0118-00: Engine Coolant Temperature Circuit High Input
- DTC P0119-00: Engine Coolant Temperature Circuit Intermittent
- DTC P0121-00: Throttle Position Sensor 1 Signal Circuit Range/Performance
- DTC P0122-00: Throttle Position Sensor 1 Signal Circuit Low Input
- DTC P0123-00: Throttle Position Sensor 1 Signal Circuit High Input
- DTC P0125-00: Insufficient Coolant Temperature For Closed Loop Fuel Control
- DTC P0128-00: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature)
- DTC P0131-00: O2 Sensor Circuit Low Voltage (Bank 1/Sensor 1)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
