2023 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE

Removal & Installation: Removal

Information 

If necessary to replace the Fuel Pump Control Module (FPCM), replace the plate cover assembly.

  1. Remove the fuel pump module.

    (Refer to Fuel Delivery System - "FUEL PUMP MODULE ")

  2. Disconnect the fuel pump motor connector (A) and fuel sender connector (B).
    G15693480Courtesy of KIA MOTORS AMERICA, INC.
  3. Separate the feed tube (A) after removing the clip (B).
    G15693481Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the fuel pump plate assembly (A).
    G15693482Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the O-ring (A).
    G15693483Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the Fuel Pressure Sensor (FPS) (A) after removing the clip (B).
    G15693484Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the Fuel Tank Pressure Sensor (FTPS) (A).
G15693485Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.