2023 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE

Description & Operation: Operation

G15693479Courtesy of KIA MOTORS AMERICA, INC.
  1. The Engine Control Module (ECM) sends target fuel pressure to the Fuel Pump Control Module (FPCM) via CAN network.
  2. The Fuel Pressure Sensor (FPS) sends to the FPCM measures the fuel pressure of the low pressure fuel line between the low pressure and high pressure fuel pump. The FPCM sends this pressure information to the ECM. In addition, the FPCM sends faulty information to ECM after diagnosis the fuel pump motor, FPS and the system, including the self-diagnosis.
  3. The FPCM compares the actual fuel pressure measured by the FPS with the target fuel pressure provided by the ECM and controls the voltage provided to the low pressure fuel pump motor. The FPCM keeps regulating fuel flow rate by controlling the low pressure fuel pump, depending on engine speed (rpm) and vehicle loads.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.