Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE
Description & Operation: Description
- Installed on the fuel tank, the Fuel Pump Control Module (FPCM) controls the pump motor mounted inside the low pressure fuel pump.
- The actual pressure measured by the pressure sensor and the target pressure are compared to control the voltage applied to the fuel pump in real time.
- When fuel pump/controller/pressure sensor/system are diagnosed as faults, the information is transmitted to Engine Control Module (ECM).
- If there is fault diagnosis, the fuel pump will be activated forcibly by the mode that has been set.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
