Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Kia Telluride EX, FWDFACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (3 Of 12)
- DTC Index
- DTC P0111-00: Intake Air Temperature Sensor 1 Circuit Range/Performance
- DTC P0112-00: Intake Air Temperature Sensor 1 Circuit Low Input
- DTC P0113-00: Intake Air Temperature Sensor 1 Circuit High Input
- DTC P0116-00: Engine Coolant Temperature Circuit Range/Performance
- DTC P0117-00: Engine Coolant Temperature Circuit Low Input
- DTC P0118-00: Engine Coolant Temperature Circuit High Input
- DTC P0119-00: Engine Coolant Temperature Circuit Intermittent
- DTC P0121-00: Throttle Position Sensor 1 Signal Circuit Range/Performance
- DTC P0122-00: Throttle Position Sensor 1 Signal Circuit Low Input
- DTC P0123-00: Throttle Position Sensor 1 Signal Circuit High Input
- DTC P0125-00: Insufficient Coolant Temperature For Closed Loop Fuel Control
- DTC P0128-00: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature)
- DTC P0131-00: O2 Sensor Circuit Low Voltage (Bank 1/Sensor 1)
- DTC P0132-00: O2 Sensor Circuit High Voltage (Bank 1/Sensor 1)
- DTC P0133-00: O2-Sensor Circuit Slow Response (Bank 1/Sensor 1)
- DTC P0135-00: O2 Sensor Heater Circuit (Bank 1/Sensor 1)
- DTC P0136-00: O2 Sensor Circuit (Bank 1/Sensor 2)
- DTC P0137-00: O2 Sensor Circuit Low Voltage (Bank 1/Sensor 2)
- DTC P0138-00: O2 Sensor Circuit High Voltage (Bank 1/Sensor 2)
- DTC P0139-00: O2 Sensor Circuit Slow Response (Bank 1/Sensor 2)
- DTC P0140-00: O2 Sensor Circuit No Activity Detected (Bank 1/Sensor 2)
- DTC P0151-00: O2 Sensor Circuit Low Voltage (Bank 2/Sensor 1)
- DTC P0152-00: O2 Sensor Circuit High Voltage (Bank 2/Sensor 1)
- DTC P0153-00: O2 Sensor Circuit Slow Response (Bank 2/Sensor 1)
- DTC P0155-00: O2 Sensor Heater Circuit (Bank 2 Sensor1)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
