Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Kia Soul X LineFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Inspection
- Turn ignition switch OFF.
- Disconnect the VCMA connector.
- Check that the VCMA is not stuck by foreign material.
- Measure resistance between motor (+) and (-) control terminals of the motor.
- Check that the resistance is within the specification.
Specification : 3.4 - 4.4 Ω [20°C (68°F)]
- Measure resistance between voltage supply terminal and ground terminal of the position sensor.
- Check that the resistance is within the specification.
Specification : 3.44 - 5.16 Ω [20°C (68°F)]
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.