Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Kia Seltos EXFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Cleaning
- Remove the ETC.
(Refer to ETC - "REMOVAL ")
NOTE: Cleaning the ETC after removing it. - Clean the pollutant in the throttle body using a soft cloth moistened with cleaning fluid.NOTE:
- Take care not to getting into foreign matter for ETC.
- Do not spray cleaning fluid to ETC directly and use a lint free cloth moistened by cleaning fluid.
- Be careful as fingers or cloth may get caught in the valve.
- Be careful not to clean the coating fluid around the shaft. If coating fluid is removed, idling control failure might occur by foreign matter inflow or excessive air leakage.
- Install the ETC.
(Refer to ETC - "INSTALLATION ")
- Reset the ETC adaptive value.
- Perform the ETC learning procedure.
(Refer to ETC - "ADJUSTMENT ")
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.