2022 Kia K5 GTFACTORY OEM SERVICE PROCEDURE

E-CVVT Cover

  1. Remove the vacuum pump.

    (Refer to " Removal  ") 

  2. Remove the engine mounting support bracket.

    (Refer to " Engine Mounting Bracket  ") 

  3. Remove the engine support bracket (A) after removing the mounting bolts.

    Information 

    Remove in order of 6→5→4→3→2→1

    Fig 1: Engine Support Bracket Bolts Loosening Sequence
    G13837475Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the E-CVVT cover connector (A).
    G13837476Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the E-CVVT cover (A) after removing the mounting bolts.
    G13837477Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Be careful not to apply the force on the connector brush after removing the E-CVVT cover.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.