2022 Kia Carnival EXFACTORY OEM SERVICE PROCEDURE

Automatic Transaxle System DTCS

AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Description
P0601-00 Internal Control Module Memory Check Sum Error
P0705-12 Transmission Range Sensor Circuit Malfunction (PRNDL Input)
P0705-14 Transmission Range Sensor Circuit Malfunction (PRNDL Input)
P0705-1C Transmission Range Sensor Circuit Malfunction (PRNDL Input)
P0706-61 Transmission Range Sensor Circuit Range/Performance
P0706-96 Transmission Range Sensor Circuit Range/Performance
P0712-00 Transmission Fluid Temperature Sensor 'A' Circuit Low Input
P0713-00 Transmission Fluid Temperature Sensor 'A' Circuit High Input
P0717-00 Input/Turbine Speed Sensor 'A' Circuit No Signal
P0721-00 Output Speed Sensor Circuit Range/Performance
P0722-00 Output Speed Sensor Circuit No Signal
P0729-00 Gear 6 Incorrect Ratio
P0730-00 Gear 8 Incorrect Ratio
P0731-00 Gear 1 Incorrect Ratio
P0732-00 Gear 2 Incorrect Ratio
P0733-00 Gear 3 Incorrect Ratio
P0734-00 Gear 4 Incorrect Ratio
P0735-00 Gear 5 Incorrect Ratio
P0741-00 Torque Converter Clutch Circuit Performance or Stuck Off
P0743-00 Torque Converter Clutch Circuit Electrical
P0748-00 Pressure Control Solenoid Valve (VFS) 'A' Electrical
P0753-00 Shift Control Solenoid Valve 'A' Electrical (UD/C)
P0758-00 Shift Control Solenoid Valve 'B' Electrical (46/C)
P0763-00 Shift Control Solenoid Valve 'C' Electrical (37R/C)
P0768-00 Shift Control Solenoid Valve 'D' Electrical (OD & LR)
P076F-00 Gear 7 Incorrect Ratio
P0773-00 Shift Control Solenoid Valve 'E' Electrical (28/B)
P0791-00 Intermediate Shaft Speed Sensor 'A' Circuit
P07FF-00 SBW System Error
P0880-00 TCM Power Input Signal
P0955-00 Auto Shift Manual Mode Circuit
P1602-00 No EOL Data
P2709-00 Shift Control Solenoid Valve 'F' Electrical
U0001-00 High Speed CAN Communication Bus
U0100-00 Lost Communication with ECM/PCM 'A'
U1117-88 High Speed CAN2 Communication (EMS-DCT)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.