Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Kia Carnival EXFACTORY OEM SERVICE PROCEDURE
Removal & Installation: Removal
- Remove the air cleaner.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- Disconnect the Engine Control Module (ECM) connectors (A).
- Separate the wiring fixing clip (A) from the ECM bracket.
- Remove ECM (A) to upward after releasing the fixed hook (B) by pulling in the direction of the arrow.
- Remove the ECM (A) from the bracket after removing the mounting nuts.
Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.