2021 Kia Telluride EX, 4WDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install in the reverse order of removal.
    NOTE:
    1. Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
    2. Smear and cover splines (B) with molybdenum type high pressure grease.

      GREASE SPL-1 or equivalent

      G13310519Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the propeller shaft to be near runout marking (Transfer assembly 1ea (A), propeller shaft 1ea (B)) each other.
    G13310520Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.