2021 Kia Telluride EX, 4WDFACTORY OEM SERVICE PROCEDURE

Component Inspection

Inspection Condition (+) Probe (-) Probe Reference
Connector Terminal Connector Terminal
  1. Engine "ON"
HO2S (Bank2, Sensor1) connector 1 (nernst voltage) HO2S (Bank2, Sensor1) connector 3 (virtual ground) Figure 1 below
HO2S (Bank2, Sensor1) connector 4 (trim resister) HO2S (Bank2, Sensor1) connector 6 (pumping current)
G13335159Courtesy of KIA MOTORS AMERICA, INC.

Good 

No Good 

  • Carefully re-do this troubleshooting guide steps.
  • If no problems were found with the circuits or connectors, replace the HO2S (Bank2, Sensor1) and go to "VERIFICATION OF REPAIR " procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.