Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia Telluride EX, 4WDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Installation
- Install in the reverse order of removal.
NOTE:
- For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when replacing or recharging the battery.
- When replacing the battery, a battery of the same type, capacity and brand as the previously installed battery should be used. If the vehicle is replaced with a battery of a different type, the battery sensor may recognize it as abnormal.
- When installing the battery, fix the mounting bracket on the tray correctly.
- When installing the ground cable on the negative post of battery, tighten the clamp to the specified torque. Excessive tightening can damage the PCB internal circuit and the battery terminal.
- After disconnecting then reconnecting the battery negative cable, reset some parts that require the reset procedures.
(Refer to Body Electrical System - "GENERAL INFORMATION ")
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.