Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia Stinger GT-Line, RWDFACTORY OEM SERVICE PROCEDURE
4WD Control DTCS
4WD CONTROL DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC P0602 | 41: ECU Internal Error - SW |
| DTC P0602 | 47: ECU Internal Error - HW |
| DTC P0602 | 49: Motor Driver Error |
| DTC P1780 | 16: Battery Voltage Low |
| DTC P1821 | 11: Motor Wire Short to Ground |
| DTC P1821 | 12: Motor Wire Short to Battery |
| DTC P1821 | 13: Motor Wire Open |
| DTC P1825 | 11: Pressure Sensor Supply Voltage Low |
| DTC P1825 | 12: Pressure Sensor Supply Voltage High |
| DTC P1827 | 11: Pressure Sensor Signal Voltage Low |
| DTC P1827 | 12: Pressure Sensor Signal Voltage High |
| DTC P1829 | 00: Clutch Torque Tolerance Limit Exceed |
| DTC P1830 | 00: Clutch Thermal Overstress |
| DTC P1836 | 00: Pressure Line Check Error |
| DTC P3114 | 00: Vehicle Information Option Not Detected Or Invalid |
| DTC P3119 | 00: Front/Rear Tire Difference Too Big or All Wheel Information Missing |
| DTC U0001 | 88: High Speed CAN Bus-Off |
| DTC U0100 | 87: Lost Communication with EMS |
| DTC U0101 | 87: Lost Communication With TCU |
| DTC U0122 | 87: Lost Communication With ESC |
| DTC U0126 | 87: Lost Communication With MDPS |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.