Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia Soul X LineFACTORY OEM SERVICE PROCEDURE
Removal And Installation
- Turn ignition switch OFF and disconnect the battery negative (-) terminal.
- Disconnect the canister close valve extension connector (A).
- Disconnect the ventilation hose (A).
- Remove installation clip (B) and then remove the fuel tank air filter & canister close valve.
- Separate the canister close valve (A) from the fueltank air filter (B).
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.