2021 Kia Sorento Hybrid EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the auxiliary battery negative (-) terminal.

    (Refer to Engine Electrical System - "AUXILIARY BATTERY ")

  2. Disconnect the SCU connector (A).
    G13576340Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the SCU (A) by removing the nuts.

    Tightening torque  :

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G13576341Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.