Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia Sorento Hybrid EXFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
CAUTION:
Do not remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flow out engine oil may occur.
- Disconnect the negative (-) battery terminal.
(Refer to Engine Electrical System - " AUXILIARY BATTERY ")
- Disconnect the Camshaft Position Sensor (CMPS) connector (A).
[Intake]
[Exhaust]
- Remove the CMPS by removing the mounting bolt (A).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)
[Intake]
[Exhaust]
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
