2021 Kia Sorento EX, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  2. Disconnect the Engine Control Module (ECM) connector (A).
    G13664718Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the ECM (A) by pulling it in the arrow direction after releasing the hooks.
    G13664719Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the bracket from the ECM (A) after removing the mounting bolts.

    Tightening torque:Β 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

    G13664720Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.