Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Adjustment
- Perform the neutral mode using the KDS when replacing with a reused ECM.
[Non-Smart Key]
[Smart Key]
- Perform the "Key Teaching" procedure by using the KDS.
[Non-Smart Key]
[Smart Key]
Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
- Perform the VIN writing procedure by using the KDS.
- Perform ETC module learning procedure
(Refer to Electronic Throttle Control System - "ADJUSTMENT ")
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
