2021 Kia Seltos EXFACTORY OEM SERVICE PROCEDURE

Neutralization Status Check

  1. Connect the VCI dongle of the KDS to the data link connector in driver side crash pad lower panel.
  2. After IG ON, select the "Neutralization mode".
    G13482101Courtesy of KIA MOTORS AMERICA, INC.
    G13482102Courtesy of KIA MOTORS AMERICA, INC.
    G13482103Courtesy of KIA MOTORS AMERICA, INC.
    G13482104Courtesy of KIA MOTORS AMERICA, INC.
    G13482105Courtesy of KIA MOTORS AMERICA, INC.
    G13482106Courtesy of KIA MOTORS AMERICA, INC.
    G13482107Courtesy of KIA MOTORS AMERICA, INC.
    G13482108Courtesy of KIA MOTORS AMERICA, INC.
    G13482109Courtesy of KIA MOTORS AMERICA, INC.
    G13482110Courtesy of KIA MOTORS AMERICA, INC.
    G13482111Courtesy of KIA MOTORS AMERICA, INC.
    G13482112Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.