2021 Kia Seltos EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn ignition OFF and disconnect the negative (-) battery cable.
  2. Remove the Intercooler inlet hose and Intercooler inlet pipe.[G 1.6 T-GDI GAMMA only] 

    G 1.6 T-GDI GAMMA  (Refer to Engine Mechanical System - "INTAKE AND EXHAUST SYSTEM ")

  3. Disconnect the battery negative wirings (A).

    Tightening torque: 

    10.8 - 13.7 N.m (1.1 - 1.4 kgf.m, 8.0 - 10.1 lb.ft)

    G13481805Courtesy of KIA MOTORS AMERICA, INC.
  4. Pull up the ESC connector lock (A) and then disconnect the connector.
    G13481806Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the brake lines (A, B) from the ESC by unlocking the nuts counterclockwise with a wrench.

    Tightening torque: 

    A:  12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb.ft)

    B (ABS):  12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb.ft)

    B (ESC):  18.6 - 22.6 N.m (1.9 - 2.3 kgf.m, 13.7 - 16.6 lb.ft)

    G13481807Courtesy of KIA MOTORS AMERICA, INC.
  6. Loosen the ESC bracket nuts, and then remove ESC control unit (A).

    Tightening torque: 

    16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb.ft)

    G13481808Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Never attempt to disassemble the ESC module.
    • Never drop the ESC module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.