2021 Kia Seltos EXFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure By Using Diagnostic Device

Perform diagnostic procedure by using diagnostic device as shown below:

Connect self-diagnosis connector (16pins) located under the driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.

Select the "vehicle model" and "ABS/ESC" on KDS vehicle selection screen, then select OK.

[Variant Coding]Β 

G13481809Courtesy of KIA MOTORS AMERICA, INC.
G13481810Courtesy of KIA MOTORS AMERICA, INC.

[Auto Detected Sensor Calibration]Β 

G13481811Courtesy of KIA MOTORS AMERICA, INC.
G13481812Courtesy of KIA MOTORS AMERICA, INC.

[Longitudinal G Sensor Calibration]Β 

G13481813Courtesy of KIA MOTORS AMERICA, INC.
G13481814Courtesy of KIA MOTORS AMERICA, INC.

[Assembly Check]Β 

G13481815Courtesy of KIA MOTORS AMERICA, INC.
G13481816Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.