Adaptive Front Lighting System DTCS

2021 Kia Sedona EXSECTION Adaptive Front Lighting System DTCS
ADAPTIVE FRONT LIGHTING SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Description
DTC B1101 17: Battery Voltage High
DTC B1102 16: Battery Voltage Low
DTC B1220 87: CAN - Speed signal fault
DTC B1301 87: CAN - Steering Angle Signal Fault
DTC B1302 87: CAN - Gearbox Signal Fault
DTC B1303 87: CAN - Accelerator Pedal Signal Fault
DTC B1304 87: CAN - Engine State Signal Fault
DTC B1305 87: CAN - Yaw Rate Signal Fault
DTC B1306 87: CAN - Brake Pedal Signal Fault
DTC B1308 87: CAN - H/Lamp Signal Fault
DTC B1594 87: CAN - Auto Position Signal Fault
DTC B1603 88: CAN - 'Bus off' fault
DTC B1621 01: ECU Hardware Fault
DTC B1622 48: ECU Software Fault
DTC B1636 88: LIN Fault - Physical Fault
DTC B1637 54: System Calibration Not Performed
DTC B1639 81: LIN Fault - Communication Error DBL Left
DTC B1661 46: Parameter Missing
DTC B1953 03: AXLE Sensor Fault
DTC B2200 81: LIN communication error DBL Right
DTC B2201 81: LIN Fault - Communication Error HLL Left
DTC B2202 81: LIN Fault - Communication Error HLL Right
DTC B2203 81: LIN communication error Shield Act. Left
DTC B2204 81: LIN communication error Shield Act. Right
DTC B2205 81: LIN communication error Ballast Left
DTC B2206 81: LIN communication error Ballast Right
DTC B2325 09: Swivel Module Fault Left
DTC B2326 09: Swivel Module Fault Right
DTC B2400 09: Leveling Motor Fault Left
DTC B2401 09: Leveling Motor Fault Right
DTC B2461 09: Shield Motor Fault Left
DTC B2462 09: Shield Motor Fault Right
DTC B2463 09: Ballast Fault Left
DTC B2464 09: Ballast Fault Right
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.