2021 Kia Niro EV EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different car, the 2019 Kia Niro EV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Disconnect the negative battery terminal.
  2. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  3. Separate the wireless charging assembly (A) by pushing in the direction of the arrow after removing the wireless charging pad (B).
    G13204202Courtesy of KIA MOTORS AMERICA, INC.
    G13204203Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the wireless charging assembly (A) after disconnecting the connector.
    G13204204Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the multimedia jack connector (A).
    G13204205Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the multimedia jack (A) after releasing the fixed hooks.
    G13204206Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.