2021 Kia K5 GTFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the battery negative (-) terminal
  2. Remove the engine room under cover.

    (Refer to " Removal And Installation  ") 

  3. Remove the intake manifold.

    (Refer to " Removal And Installation  ") 

  4. Disconnect the Oil Pressure and Temperature Sensor(OPTS) connector (A).
    G13837540Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the OPTS (A).

    Tightening torque: 

    35.3 - 38.2 N.m (3.6 - 3.9 kgf.m, 26.0 - 28.2 lb.ft)

    G13837541Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.