Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia K5 GT-Line, FWDFACTORY OEM SERVICE PROCEDURE
OCS Reset Procedure
You should perform OCS Reset procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly)
- Ignition "OFF", connect KDS.
- Ignition "ON" and Engine "OFF", select S/W Management and "Car model".
- Connect the KDS to the vehicle, select "S/W management" or "Car model"
- Select OCS and "Body Sensor Reset".
CAUTION:
- Erase the SRSCM diagnostic codes after resetting the OCS.
| DTC Code | Code Name | Description |
|---|---|---|
| B176300 | ECU Defect |
|
| B176400 | MAT Defect |
|
| B17672F | Also cut-off |
|
| B111117 | IGN voltage high |
|
| B111216 | IGN voltage low |
|
| B160388 | CAN bus off |
|
| B169787 | ACU communication error |
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
