2021 Kia K5 GT-Line, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

NOTE: If the FPCM needs to be replaced, replace the plate cover assembly.
  1. Remove the fuel pump module.

    (Refer to "Β RemovalΒ Β ")Β 

  2. Disconnect the fuel pump connector (A) and fuel sender connector (B).
    G13834192Courtesy of KIA MOTORS AMERICA, INC.
  3. After releasing the fixing clip (A), remove the fuel feed tube quick-connector (B).
    G13834193Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the stopper (A).
    G13834194Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the plate cover assembly (A) and O-ring (B).
    G13834195Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.