Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Installation
- Install in the reverse order of removalNOTE:
- Matters that require attention when installing the transaxle to engine
- Check that there is no gap between the torque converter housing (A) and the engine block (B).
- This gap means the torque converter is not assembled correctly and it can cause damage on the key (A) of oil pump gear. In this case, reinstall the torque converter correctly after removing the transaxle assembly.
- If the bolt is tightened while there is a gap, it can cause damage on the key of oil pump gear. In this case, replace the transaxle assembly after removing the mounting bolts.
- Check that there is no gap between the torque converter housing (A) and the engine block (B).
- When reinstalling
- If the differential oil seal is damaged and oil is leaking, replace the oil seal with a new one. When installing a new oil seal, use the SSTs (09452-26100, 09231-H1100).
- Check that the shift lever and manual control lever are placed in the "N" position.
- Check the ATF level after refilling the automatic transaxle with fluid.
(Refer to " Replacement ")
- Clear the diagnostic trouble codes (DTC) using the KDS.
Disconnecting the battery negative terminal will not clear the DTCs. Clear DTCs using the KDS at all times.
- When replacing with a new automatic transaxle
- Install the transaxle after draining the remaining ATF by blowing air into the ATF cooler (ATF warmer) hose.
- Check that the shift lever and manual control lever are placed in the "N" position.
- Automatic transaxle is already filled with the specified amount of ATF.
For this reason, it is not necessary to refill and check the ATF. However, the remaining ATF in the ATF cooler has to be drained.
Remanufactured automatic transaxle is not filled with specified quantity of ATF. For that reason, it is necessary to refill and check the ATF.
(Refer to " Replacement ")
- Clear the diagnostic trouble codes (DTC) using the KDS. Disconnecting the battery negative terminal will not clear the DTCs. Clear DTCs using the KDS at all times.
- Reset the automatic transaxle adaptive values using the KDS.
- Perform the oil pressure characteristics input procedure using the KDS.
- Perform the TCM adaptive values learning procedure.
(Refer to " Repair Procedures ")
- Matters that require attention when installing the transaxle to engine
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
