Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia K5 GT-Line, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Disconnect the battery negative terminal.CAUTION: After disconnecting the cables, wait at least 3 minutes.
- Remove the floor console assembly.
(Refer to "Β ReplacementΒ ")Β
- Disconnect the SRSCM connectors (A).
- Remove the SRSCM (A) by loosening the bolt and nuts.
Tightening torque:Β
Bolt: 10.8- 13.7 N.m (1.1 - 1.4kgf.m, 8.0-10.1 lbf.ft)
Nut: 6.9 - 11.8 N.m (0.7 - 0.8 kgf.m, 5.0 - 5.8 lb.ft, 60.8 - 69.4 lb.in)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
