2021 Kia K5 EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Shift transmission to "N".
  2. Remove the floor console assembly.

    (Refer to "Β ReplacementΒ  ")Β 

  3. Disconnect the main connector (A).
    G13834278Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the snap pin (A).
    G13834279Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the shift cable (A) from the shift lever.
    G13834280Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the shift lever assembly (A).

    Tightening torque:Β 

    8.8 - 13.7 N m (0.9 - 1.4 kgf m, 6.5 - 10.1 lb ft)

    G13834281Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.