Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia K5 EXFACTORY OEM SERVICE PROCEDURE
Failure Test
- Initial test is performed immediately after the HECU is powered on.
- Valve relay test is performed immediately after switching "ON" the IG2.
- Test are performed at all times the ignition (IG2) is ON.
- Initial test is performed in the following cases.
- When the failure is not detected momentarily
- When ABS and ESC are not in control.
- If initial test is not made after supplying power to ECU.
- If the vehicle speed is over 5 mph (8 km/h) with the brake lamp switched off.
- When the vehicle speed is over 24.8 mph (40 km/h).
- Test continues even if the brake lamp is switched on.
- When performing ABS or ESC control before the initial test, stop the initial test and wait for the HECU power input again.
- Judge failure in the following cases.
- When the power is normal.
- From the point in which the vehicle speed reaches 4.9 mph(8 km/h) after HECU power on.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
