Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TCM Adaptive Values Learning Procedure
- P range learning (learning condition: IVTF temperature: 30 - 90°C (86 - 194°F), shift lever P range, brake off)
- Start the engine after checking for the IVT fluid temperature in state of IG ON.
- Engine RPM will rise to approximately 1000 rpm after starting the engine.
- After 30 seconds to 2 minutes, the learning is completed when the engine RPM reaches the IDLE level.
(Learning completion can be confirmed from the "Sensor Data" of KDS)
(If operated during learning, it needs to be re-engaged after starting off)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.