Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Kia Forte GT, Standard TransFACTORY OEM SERVICE PROCEDURE
Special Service Tools
| Tool Name/Number | Illustration | Description |
|---|---|---|
| Fuel pressure gauge 09353-24100 |
Used for measuring the pressure in fuel line | |
| Fuel pressure gauge adapter 0K353-D4100 |
Used for connecting between high pressure fuel pump and low pressure fuel feed tube to measure the pressure in fuel line | |
| Heated oxygen sensor socket wrench 09392-1Y100 |
Used for removing/installing heated oxygen sensor * KSST 09392-2H100 also can be used |
|
| Torque wrench socket 09314-3Q100 or 09314-27130 (19 mm) |
Used for removing/installing high pressure fuel pipe | |
| Injector combustion seal guide & sizing tool 09353-2B000 |
Used for installing injector combustion seal on injector |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.