2021 Kia Forte FE, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Shift the gear to "N".
  2. Remove the air duct and air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Remove the shift cable (A) from the bracket after loosening a nut (B).
    G13307387Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the knob (A) by pulling it in the direction of arrow after removing the boots from the console upper cover.
    G13307388Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  7. Remove the shift cable from the shift lever pin after removing the snap pin (A).
    G13307389Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the cable socket (A) from the shift lever.
    G13307390Courtesy of KIA MOTORS AMERICA, INC.
  9. Remove the shift cable retainer (A) after loosening the nuts (B).

    Then, remove the shift cable by pulling it toward the vehicle interior.

    G13307391Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.