2021 Kia Forte FE, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

NOTE:
  • Intelligent Variable Transmission (IVT) is composed of delicate components. Be careful not to cause any damage on the component when assembling and disassembling.
  • Maintain clean condition so that foreign substance does not get into the Intelligent Variable Transmission (IVT).
  • Use a coated apron, latex gloves, and stainless tray to prevent foreign substance from getting into the Intelligent Variable Transmission (IVT).
  1. Remove the under cover

    (Refer to Engine Mechanical System - ENGINE ROOM UNDER COVER

  2. Remove the IVTF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.

    Tightening torque: 

    34.3 - 39.2 N-m (3.5 - 4.0 kgf-m, 25.3 - 28.9 lb-ft)

    G00599933Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Intelligent variable transmission fluid (IVTF) can be reused. Collect it using a clean 10-liter beaker.
    • The existing IVTF drain plug gasket must be replaced.
  3. Remove the valve body cover (A).
    G00599934Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Be careful when removing the valve body cover because the remaining IVTF remains in the valve body cover.
  4. Remove the valve cover body gasket.
    G00599935Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the IVTF filter (A) after removing the bolts.
    G00599936Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the pressure sensor connector (A).
    G00599937Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the pressure sensor (A).
    G00599938Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.