2020 Kia Soul LX, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Move the shift lever to 4th gear.
  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the battery and battery tray.

    (Refer to Body Electrical System - "BATTERY ")

  4. Remove the control cable from the control shaft after removing the snap pins (A).
  5. Remove the select cable (B) and shift cable (C).
    G13283962Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the knob (A) by pulling it in the direction of upward after removing the boots from the console upper cover.
    G13283963Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  8. Remove the select cable.
    1. Remove the snap pin (A).
      G13283964Courtesy of KIA MOTORS AMERICA, INC.
    2. Remove the select cable (A) from the shift lever.
      G13283965Courtesy of KIA MOTORS AMERICA, INC.
  9. Remove the shift cable.
    1. Remove the snap pin (A) in the direction of the arrow.
      G13283966Courtesy of KIA MOTORS AMERICA, INC.
    2. Remove the shift cable (A) from the shift lever.
      G13283967Courtesy of KIA MOTORS AMERICA, INC.
  10. Remove the shift cable retainer (A) after loosening the nuts (B). Then, remove the shift cable by pulling it toward the vehicle interior.
    G13283968Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.