2020 Kia Soul LX, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install the shift cable retainer (A) by tightening nuts (B).

    Tightening torque:Β 

    11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb.ft)

    G13283969Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the select cable.
    1. Install the select cable (A) from the shift lever.
      G13283970Courtesy of KIA MOTORS AMERICA, INC.
    2. Install the select cable to the lever pin and then insert the snap pin (A).
      G13283971Courtesy of KIA MOTORS AMERICA, INC.
  3. Install the shift cable.
    1. Install the shift cable (A) from the shift lever.
      G13283972Courtesy of KIA MOTORS AMERICA, INC.
    2. Install the shift cable end (A).
      G13283973Courtesy of KIA MOTORS AMERICA, INC.
  4. Check that the shift lever and control shaft are placed in the "4th" position and then install the 4th fixing pin (A).
    G13283974Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the control cable.
    1. After pulling the holder (A) in the direction of the "P", pull the lock (B) in the direction of the "F".
      G13283975Courtesy of KIA MOTORS AMERICA, INC.
    2. Push the lock (A) after installing the control cable to the control shaft and cable bracket.
      G13283976Courtesy of KIA MOTORS AMERICA, INC.
    3. Insert the snap pins (A).
      G13283977Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the 4th fixing pin (A).
    G13283978Courtesy of KIA MOTORS AMERICA, INC.
  7. Check for proper operation of control shaft lever when operated (1st, 2nd, 3rd, 4th, 5th, 6th, R gear).
  8. Install the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  9. Install the battery and battery tray.

    (Refer to Body Electrical System - "BATTERY ")

  10. Install the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.