2020 Kia Sorento LFACTORY OEM SERVICE PROCEDURE

Key Interlock Switch

  1. Remove the key interlock switch (B) after removing the switch cover (A).
    G12850125Courtesy of KIA MOTORS AMERICA, INC.
  2. Remove the shift lock solenoid (A).
    G12850126Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the manual mode switch housing (A).
    G12850127Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the main connector (A).
    G12850128Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the pin fixing bracket (A) from the main connector.
    G12850129Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the pin of key interlock switch from the main connector.
    G12850130Courtesy of KIA MOTORS AMERICA, INC.
NOTE: Check the wiring color before disconnecting the wiring.
G12850131Courtesy of KIA MOTORS AMERICA, INC.
Pin Function Color
3 Key interlock switch (+) Brown
4 Key interlock switch (-) Brown
5 Manual mode "down" Red/Black
6 Manual mode "select" Red
7 Manual mode "up" White
9 Ground (IG) Black
10 Shift lock solenoid (-) White/Black
11 Shift lock solenoid (+) Black/Yellow
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.