2020 Kia Sorento LFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install the shift cable retainer (A).

    Tightening torque:Β 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

    G12850151Courtesy of KIA MOTORS AMERICA, INC.
  2. Insert the snap pin after installing the shift cable (A).
    G12850152Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Install the shift cable after checking the direction of projection to prevent incorrect assembly.
    • Mind the installation direction of snap pin and install the snap pin with the hook facing downward.
    G12850153Courtesy of KIA MOTORS AMERICA, INC.
  3. Install the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  4. Install the knob (A) by pressing it in the direction of arrow after installing the boots to the console upper cover.
    G12850154Courtesy of KIA MOTORS AMERICA, INC.
  5. Check that the shift lever and manual control lever are placed in the "N" position.
  6. Install the shift cable (B) to bracket (C) and then lightly tighten the nut (A).
    NOTE: The existing shift cable clip (A) must be replaced with new one. (Do not reuse it.)
    G12850155Courtesy of KIA MOTORS AMERICA, INC.
  7. Tighten the nut (A) to the specified torque after removing free play by pushing the shift cable in the direction of the arrow.

    Tightening torque:Β 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

    G12850156Courtesy of KIA MOTORS AMERICA, INC.
  8. Install the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  9. Install the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.