2020 Kia Sorento LFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Lift the vehicle.
  3. Disconnect the canister close valve connector (A).
  4. Disconnect the ventilation tube quick-connector (B) from the fuel tank air filter and canister close valve.
    G12848640Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the vapor tube quick-connector (A).
  6. Remove the canister assembly bracket (D) after removing the mounting bolts (B) and nut (C).
    G12848641Courtesy of KIA MOTORS AMERICA, INC.
  7. Disconnect the CCV Connector (A).
    G12848642Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the fuel tank air filter & canister close valve assembly (A) after rotating it in the direction of the arrow in the figure.
    G12848643Courtesy of KIA MOTORS AMERICA, INC.
    G12848644Courtesy of KIA MOTORS AMERICA, INC.
  9. Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.
    G12848645Courtesy of KIA MOTORS AMERICA, INC.
    G12848646Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.