Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Kia Rio LXFACTORY OEM SERVICE PROCEDURE
Driver Power Window Switch
- Disconnect the negative (-) battery terminal.
- Remove the front left door trim.
- Disconnect the power window switch connector from the door trim.
- Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
[Front/Rear Driver Safety - Auto Up/Down]
[Front Driver Safety - Auto Up/Down]
[Front/Rear Auto Down]
[Front Auto Down]
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.