2020 Kia Optima Plug-In Hybrid EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Disassembly

  1. Disconnect the battery negative cable.
  2. Remove the steering wheel assembly.

    (Refer to Steering System - "REMOVAL AND INSTALLATION ")

  3. Loosen the screw and then remove the paddle shift switch (A).

    [LHS] 

    G13362656Courtesy of KIA MOTORS AMERICA, INC.
    G13362657Courtesy of KIA MOTORS AMERICA, INC.

    [RHS] 

    G13362658Courtesy of KIA MOTORS AMERICA, INC.
    G13362659Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the paddle switch connector (A).

    [LHS] 

    G13362660Courtesy of KIA MOTORS AMERICA, INC.

    [RHS] 

    G13362661Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the steering back cover (A).
    G13362662Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the connector (A) from the steering wheel remote control.

    [LHS] 

    G13362663Courtesy of KIA MOTORS AMERICA, INC.

    [RHS] 

    G13362664Courtesy of KIA MOTORS AMERICA, INC.
  7. Loosen the screw and then remove the steering wheel remote control (A).
    G13362665Courtesy of KIA MOTORS AMERICA, INC.
    G13362666Courtesy of KIA MOTORS AMERICA, INC.
  8. Disconnect the heated connector and then remove the heated wire.
    G13362667Courtesy of KIA MOTORS AMERICA, INC.
  9. Loosen the screw and then remove the steering wheel remote control (A).

    [LHS] 

    G13362668Courtesy of KIA MOTORS AMERICA, INC.

    [RHS] 

    G13362669Courtesy of KIA MOTORS AMERICA, INC.
  10. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.