2020 Kia Optima Plug-In Hybrid EXFACTORY OEM SERVICE PROCEDURE

Neutralization Status Check

WARNING: This page is about a different variant/trim than selected.
  1. Connect the cable of KDS to the data link connector in driver side crash pad lower panel.
  2. After IG ON, select the "Neutralization mode".
    G13390810Courtesy of KIA MOTORS AMERICA, INC.
    G13390811Courtesy of KIA MOTORS AMERICA, INC.
    G13390812Courtesy of KIA MOTORS AMERICA, INC.
    G13390813Courtesy of KIA MOTORS AMERICA, INC.
    G13390814Courtesy of KIA MOTORS AMERICA, INC.
    G13390815Courtesy of KIA MOTORS AMERICA, INC.
    G13390816Courtesy of KIA MOTORS AMERICA, INC.
    G13390817Courtesy of KIA MOTORS AMERICA, INC.
    G13390818Courtesy of KIA MOTORS AMERICA, INC.
    G13390819Courtesy of KIA MOTORS AMERICA, INC.
    G13390820Courtesy of KIA MOTORS AMERICA, INC.
    G13390821Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.