2020 Kia Optima Plug-In Hybrid EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

G13361523Courtesy of KIA MOTORS AMERICA, INC.
  1. Open the trunk.
  2. Remove the luggage side trim [RH] side cover.
  3. Turn ignition switch OFF and disconnect the battery negative (-) terminal (A).
  4. Disconnect the battery sensor connector (B).

    Battery (-) terminal tightening nut:Β 

    7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.2 - 8.7 lb.ft)

    G13361524Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the battery sensor by loosening the mounting bolt (A).

    Battery sensor cable flange mounting bolt (Chassis ground):Β 

    10.8 - 13.7 N.m (1.1 - 1.4 kgf.m, 8.0 - 10.1 lb.ft)

    G13361525Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.