2020 Kia K900FACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  2. Loosen the mounting bolt (A) from the lower side of floor console assembly.

    Tightening torque:Β 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)

    G13143666Courtesy of KIA MOTORS AMERICA, INC.
  3. Loosen the E-shifter mounting bolts (A) and screws (B).

    Tightening torque:Β 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)

    G13143667Courtesy of KIA MOTORS AMERICA, INC.
    G13143668Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the E-shifter after disconnecting the connector.
    1. E-shifter connector
    2. Drive mode switch connector
    3. AVN keyboard assembly connector
    4. Wiring fixing clip
    G13143669Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the AVN keyboard assembly (A) after loosening the mounting screws.
    G13143670Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the drive mode switch (A) after loosening the mounting screws.
G13143671Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.