Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Kia K900FACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (6 Of 9)
- DTC Index
- DTC P0461-00: Fuel Level Sensor 'A' Circuit Range/Performance
- DTC P0462-00: Fuel Level Sensor 'A' Circuit Low Input
- DTC P0463-00: Fuel Level Sensor 'A' Circuit High Input
- DTC P0504-00: Brake Switch 'A'/'B' Correlation
- DTC P0506-00: Idle Air Control System-RPM Lower Than Expected
- DTC P0507-00: Idle Air Control System-RPM Higher Than Expected
- DTC P050A-00: Cold Start Idle Air Control System Performance
- DTC P050B-00: Cold Start Ignition Timing Performance
- DTC P0521-00: Engine Oil Pressure Sensor/Switch 'A' Range/Performance
- DTC P0522-00: Engine Oil Pressure Sensor/Switch 'A' Low
- DTC P0523-00: Engine Oil Pressure Sensor/Switch 'A' High
- DTC P0524-00: Engine Oil Pressure Too Low
- DTC P052A-00: Cold Start 'A' Camshaft Position Timing Over-Advanced (Bank 1 In-Cam)
- DTC P052C-00: Cold Start 'A' Camshaft Position Timing Over-Advanced (Bank 2 In-Cam)
- DTC P0532-00: A/C Refrigerant Pressure Sensor 'A' Circuit Low Input
- DTC P0533-00: A/C Refrigerant Pressure Sensor 'A' Circuit High Input
- DTC P053F-00: Cold Start Fuel Pressure Performance
- DTC P0557-00: Brake Booster Pressure Sensor Circuit Low
- DTC P0558-00: Brake Booster Pressure Sensor Circuit High
- DTC P0560-00: System Voltage
- DTC P0562-00: System Voltage Low
- DTC P0563-00: System Voltage High
- DTC P0564-00: Cruise Control Multi-Function Input A Circuit
- DTC P0597-00: Thermostat Heater Control Circuit/Open
- DTC P0598-00: Thermostat Heater Control Circuit Low
- DTC P0599-00: Thermostat Heater Control Circuit High
- DTC P05CC-00: Cold Start 'A' Camshaft Position Timing Performance Bank 1
- DTC P05CD-00: Cold Start 'A' Camshaft Position Timing Performance Bank 2
- DTC P05CE-00: Cold Start 'B' Camshaft Position Timing Performance Bank 1
- DTC P05CF-00: Cold Start 'B' Camshaft Position Timing Performance Bank 2
- DTC P0605-00: Internal Control Module Read Only Memory (ROM) Error
- DTC P0606-00: ECM/PCM Processor
- DTC P0607-00: Control Module Performance
- DTC P0610-00: Control Module Vehicle Option Error
- DTC P0616-00: Starter Relay Circuit Low
- DTC P0617-00: Starter Relay Circuit High
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
