2020 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Before installation, insert "N range fixing pin" (A) of shift lever after checking the shift lever and manual control lever are on "N" range.
    G13307392Courtesy of KIA MOTORS AMERICA, INC.
  2. Install the shift cable retainer (A) by tightening nuts (B).

    Tightening torque: 

    11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb.ft)

    G13307393Courtesy of KIA MOTORS AMERICA, INC.
  3. Install the cable socket (A).
    G13307394Courtesy of KIA MOTORS AMERICA, INC.
  4. Install the shift cable to the lever pin and then insert the snap pin (A).
    G13307395Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Install the shift cable after checking the direction of projection to prevent incorrect assembly.
      G13307396Courtesy of KIA MOTORS AMERICA, INC.
    • Mind the installation direction of snap pin and install the snap pin with the hook facing upward.
      G13307397Courtesy of KIA MOTORS AMERICA, INC.
  5. Tighten the nut (B) to the specified torque after removing free play by pushing the shift cable (A) in the direction of the arrow.

    Tightening torque: 

    9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb.ft)

    G13307398Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: The existing shift cable clip must be replaced with new one. (Do not reuse it.)
    G13307399Courtesy of KIA MOTORS AMERICA, INC.
  6. Make sure to get rid of "N range fixing pin" (A) after installing the shift lever assembly.
    G13307400Courtesy of KIA MOTORS AMERICA, INC.
  7. Install the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  8. Install the knob (A) by pressing it in the direction of arrow after installing the boots to the console upper cover.
    G13307401Courtesy of KIA MOTORS AMERICA, INC.
  9. Install the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  10. Install the air duct and air cleaner assembly.

    (Refer to Engine Mechanical System - " AIR CLEANER  ") 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.