2020 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Replacement

NOTE:
  • Be sure to use the genuine IVTF (SP-CVT1).
  • When replacing with non-genuine IVT fluid, bad shift and vibration may occur, causing damage to the IVT.
  • Non-genuine IVT fluid includes aftermarket IVT fluid indicated as interchangeable with genuine Kia fluid.
  1. Remove the under cover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  2. Remove the IVTF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.

    Tightening torque: 

    34.3 - 39.2 N.m (3.5 - 4.0 kgf.m, 25.3 - 28.9 lb.ft)

    G13307438Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: The existing IVTF drain plug gasket must be replaced with a new one. (Do not reuse it.)
  3. Remove the air duct and air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  4. Remove the IVTF injection plug (A).
    G13307439Courtesy of KIA MOTORS AMERICA, INC.
  5. Fill the intelligent variable transmission with about 5.0 liters of SP-CVT1 through the IVTF filler hole.
  6. Perform the IVTF level check procedure.

    (Refer to Fluid - "INSPECTION ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.