Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Kia Forte EXFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Inspection
[Motor]
- Turn the ignition switch OFF.
- Disconnect the EEGR valve connector.
- Check that the EEGR valve is stuck by foreign material.
- Measure resistance between motor 1 and 3 control terminals of the motor.
- Check that the resistance is within the specification.
- Specification
| Item | Specification |
|---|---|
| Supply Voltage (V) | 9 - 16 |
[Feedback Position Sensor]
- Connect the KDS to the data link connector.
- Perform the fully open and the fully closing operation of the EEGR valve by using the actuation test.
- Check that the voltage is within the specification
- Specification
| Item | Specification |
|---|---|
| Opened Voltage (V) | 0.7 - 1.3 |
| Closed Voltage (V) | 3.9 - 4.5 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.