Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Removal
- Turn ignition OFF and disconnect the negative (-) battery cable.
- Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- Remove the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
- Remove the surge tank.
(Refer to Engine Mechanical System - "SURGE TANK ")
- Remove the horn.
(Refer to Body Electrical System - "HORN ")
- Remove the bracket.
- Remove the engine hanger bracket.
- Pull up the lock of the ESP connector (A) and then disconnect the connector.
- Disconnect the brake tubes from the ESP by unlocking the nuts counterclockwise with a spanner.
Tightening torque:Β
Flare nuts (B) 13.7 - 16.7 N.m (1.4 - 1.7 kgf.m, 10.1 - 12.2 lb.ft)
Flare nuts (C) 18.6 - 22.6 N.m (1.9 - 2.3 kgf.m, 13.7 - 16.6 lb.ft)
- Loosen and remove the ESP control module bolt (A).NOTE:
- Do not attempt to disassemble the HECU.
- Do not impact the HECU.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
